![]() ![]() You need a fully working BMC TrueSight environment: Setting up Hardware Sentry KM to Monitor a Brocade SAN Switch Additional Pre-requisites You will then have to use the Server Management Console or Web-Start URL to configure the SMI. During the installation process, you will have to select either the SAN+IP installation type and SMI Agent Only. You must download Brocade DCFM or Network Advisor to install the Integrated SMI Agent. This can be done directly on the switch itself by connecting to its Web management interface. ![]() SNMP must have been enabled on the Brocade SAN switch. Pre-requisites If Leveraging the SNMP Agent To know which metrics are collected, refer to: Depending on the instrumentation chosen, the collected metrics will differ. Once properly installed and configured, Hardware Sentry KM constantly monitors your Brocade SAN switch. the Brocade SNMP Agent which is based on the Fiber Alliance Management MIB (fcSwitch-MIB).Solution Brocade SAN Switch Instrumentation This article applies to Brocade SAN switches as well as to any SAN switch OEM’ed from Brocade. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |